Guides & Tutorials

How to Hang Curtains: Rod Height, Width and Length That Look Right

Hang the rod high and wide, use 2–2.5 times the width in fabric and end the hem at the floor. Get the numbers, then preview them on a photo of your window.

Mia Anderson
Mia Anderson
Senior Interior Design Writer
October 30, 20269 min read
How to hang curtains: floor-length linen curtains on a rod mounted high above a tall living room window

How to hang curtains correctly comes down to three numbers: mount the rod 4–10 in (10–25 cm) above the window frame, extend it at least 4 in (10 cm) past each side, and buy panels that add up to 2–2.5 times the width they cover. Let the hem stop a fraction of an inch above the floor and the window looks taller, wider and finished.

How to Hang Curtains: What Are the Basic Rules?

Curtains work as architecture, not just fabric. As the Wikipedia entry on curtains describes, a curtain is a piece of cloth intended to block or obscure light, drafts or the view. The way you hang it decides whether a window looks small and boxed in or tall and generous.

How to hang curtains: floor-length linen curtains on a rod mounted high above a tall living room window
A high, wide rod and floor-length panels make the window read as larger than the glass.
  • Hang the rod high: place it 4–10 in (10–25 cm) above the top of the window frame, or higher where the ceiling allows.
  • Hang the rod wide: it should extend at least 4 in (10 cm) beyond the frame on each side, and 8–12 in (20–30 cm) if you want the open curtains to clear the glass.
  • Use enough fabric: the panels together should measure 2–2.5 times the width they cover when closed.
  • End at the floor: the hem should sit about 0.25–0.5 in (6–12 mm) above the floorboards, or just kiss the floor.
  • Anchor it properly: screw into studs where you can, and use rated wall anchors where you cannot.

Sources differ slightly on the exact figures, which is why this guide gives ranges. Pick a number inside the range, then repeat it on every window in the same room so the rod lines stay level from one window to the next.

How High Should You Hang Curtain Rods?

Higher than feels natural. A rod fixed right on the window frame cuts the wall short and makes the ceiling feel lower. The most common advice is to mount it 4–10 in (10–25 cm) above the frame, with the lower end suiting a tight space and 8–10 in (20–25 cm) giving a clear lift. In a room with a very high ceiling, designers often go to 12–24 in (30–60 cm) above the frame or hang the rod just below the crown moulding.

If there is no wall left between the frame and the ceiling, mount the rod on the ceiling or the soffit instead. Whatever height you choose, keep it identical across every window on the same wall, because uneven rod lines are one of the first things the eye catches. The same trick supports the idea in our guide on making a small room look bigger: lines that draw the eye upward add perceived height.

Curtain rod height shown on a bedroom window: rod mounted well above the frame so the panels frame the glass
Mounting the rod above the frame lifts the eye and lengthens the wall.

Tip

Mark the rod height with painter's tape and a spirit level on the wall first. Step back to the doorway, look at it for a minute, then drill.

How Wide Should the Rod Be?

Wider than the window. Extending the rod past the frame lets the curtains stack against the wall when open, so they do not hide the glass. A minimum of 4 in (10 cm) per side keeps the look tidy in tight spaces, while 8–12 in (20–30 cm) per side frees almost the whole window and makes a narrow window look wider.

Measure the rod without the finials, then add the finials separately. Check what is beside the window before ordering: a wall return, a corner or a bookcase may cap how far the rod can go. For windows that sit close together, a single long rod across both is usually cleaner than two short ones.

How Much Fabric Do You Need for Curtain Width?

Curtains that close fully need roughly twice the width they cover, and 2.5 times for a richer, more tailored fold. Narrow windows can use a slightly lower ratio, around 1.5–2 times. A flat panel stretched to the exact window width looks thin and can never gather into folds, so fullness is what separates a designed window from a sheet hung on a rod.

To size the fabric, measure the width the closed curtains will cover, which is the rod width minus the finials, then multiply. A 60 in (152 cm) wide rod needs 120–150 in (305–381 cm) of fabric in total. Check the labelled width of each ready-made panel and divide, so you know whether two panels are enough or you need four.

Curtain width and fullness: pinch-pleated curtains gathered into deep folds beside a wide window
Two to two-and-a-half times the width gives soft, even folds.

How Long Should Curtains Be?

Floor length is the safe default. Measure from the point where the fabric will hang, the rod or the bottom of the rings, to the floor, then subtract about 0.5 in (1 cm) so the hem clears a rug or a floorboard edge. Ready-made panels usually come in standard heights of 84, 95 or 96, 108 and 120 in (213, 241, 274 and 305 cm). Buy the next size up and hem the excess, because a panel that is too short is the one mistake you cannot fix.

Choosing a panel length by rod height
Rod height from floorPanel to buyWhat to do
80–84 in (203–213 cm)84 in (213 cm)Use as is, or hem up to clear the floor by 0.5 in.
85–95 in (216–241 cm)95 or 96 in (241–244 cm)Hem the extra length; most windows land here.
96–107 in (244–272 cm)108 in (274 cm)Good for tall ceilings and high-mounted rods.
108–119 in (274–302 cm)120 in (305 cm)Hem to fit; check how the fabric falls at the hem.
  • Floor-skimming: the hem hovers 0.25–0.5 in (6–12 mm) above the floor. It is the cleanest look and works well with rugs and radiators.
  • Kissing the floor: the hem barely touches. It looks tailored but needs precise measuring.
  • Breaking or puddling: extra fabric folds on the floor. It looks soft and formal but collects dust and catches feet in busy rooms.

Sill-length curtains are the exception: they suit windows over a radiator, a desk or a kitchen counter. Stop them 0.5–1 in (1–2.5 cm) above the sill, but never let them stop halfway down the glass.

Curtain length guide: full-length drapes just skimming the floor of a dining room next to a wooden table
Floor-skimming curtains look tailored and stay out of the way of feet and furniture.

How Do You Install a Curtain Rod Step by Step?

1

Step 1: Choose the rod height and width

Mark the frame, add the rod height from this guide and extend each side by the width you chose, then draw a light pencil line with a level.

2

Step 2: Find the studs

Run a stud finder along the wall beside the window. If a stud is near a bracket position, shift the bracket slightly so the screws bite into wood.

3

Step 3: Fit anchors where there is no stud

Where a bracket cannot reach a stud, drill a pilot hole and install a wall anchor rated for the weight of the curtains plus the rod.

4

Step 4: Mount the brackets

Fix the end brackets first, then add a centre bracket for any rod longer than 4 ft (120 cm) so it does not sag.

5

Step 5: Hang and adjust

Slide on the rings or clips, hang the panels and check the hem against the floor. Add a second pair of hooks or hemming tape if the length is off.

Heavy lined or blackout curtains can weigh several kilograms, and a rod fixed to bare plasterboard with the wrong plugs will pull out. If you rent, ask what the lease permits before drilling, and read our guide to rental-friendly decorating for lighter options.

Should You Layer Curtains and Keep Cords Safe?

Layering gives you control over light. A sheer panel on an inner rod filters daylight while a lined or blackout panel on an outer rod closes the room at night. This is the same logic described in our guide to layering lighting: separate layers, each doing one job.

If the window also has blinds or shades, mind the cords. The US Consumer Product Safety Commission warns that pull cords, inner lift cords and continuous loops can strangle young children, and recommends cordless coverings wherever a child may be present. Its window covering safety guidance also covers shortening cords and keeping beds and cribs away from windows.

Can You Preview Curtains on a Photo of Your Room?

Yes, for the look and the proportions. In DecorAI you upload a photo of the window wall, choose a style and switch on the Window Treatments design control, and the redesign shows curtains in your real room in usually under 10 seconds. You get three free designs a day without registering, and you can compare floor-skimming against longer panels or sheer against blackout before you buy a metre of fabric.

How to hang curtains previewed on a photo: the same living room window shown with and without floor-length curtains
A photo preview helps you pick a length before you cut or order.

A preview is a visual concept, not a measured drawing, so use this guide and a tape measure for the final numbers. For the fuller picture of what AI previews can and cannot do, see our overview of how AI interior design works and what it costs, and browse the features and the FAQ on the home page.

Which Curtain-Hanging Mistakes Should You Avoid?

  1. Hanging the rod on the frame. It shortens the wall and the window; go at least 4 in (10 cm) above.
  2. Using too little fabric. Flat panels look thin; aim for 2–2.5 times the width.
  3. Buying a rod that is too narrow. Curtains that cover the glass when open block daylight; extend the rod 8–12 in (20–30 cm) per side.
  4. Choosing curtains that are too short. Panels that stop above the floor or halfway down a window look like a mistake; buy long and hem.
  5. Skipping the centre bracket. Rods over 4 ft (120 cm) sag without one.
  6. Ignoring the weight. Heavy curtains need studs or rated anchors, not light plastic plugs.

Frequently Asked Questions About Hanging Curtains

How high above the window should I hang curtains?

Hang the rod 4–10 in (10–25 cm) above the window frame, or higher if the ceiling allows. In rooms with very high ceilings, 12–24 in (30–60 cm) above the frame is common.

How wide should a curtain rod be?

Extend the rod at least 4 in (10 cm) past each side of the frame, or 8–12 in (20–30 cm) per side if you want the open curtains to clear the glass. Measure the rod without the finials.

How much fabric do I need for curtains?

The panels should add up to 2–2.5 times the width they cover when closed. A 60 in (152 cm) rod therefore needs 120–150 in (305–381 cm) of fabric.

How long should curtains be?

Floor length is the default: the hem sits about 0.25–0.5 in (6–12 mm) above the floor. Ready-made panels come in 84, 95 or 96, 108 and 120 in lengths, so buy the next size up and hem it.

Can I preview curtains before I buy them?

Yes. DecorAI lets you upload a photo of your window and use the Window Treatments control to see curtains in your room, with three free designs a day and no account. It is a visual concept, not a measured drawing.

Are curtain cords a safety risk?

Cords on blinds and shades can strangle young children, according to the US Consumer Product Safety Commission, which recommends cordless window coverings where children may be present.

CurtainsWindow TreatmentsLiving RoomBedroomDecorAI
Mia Anderson
Written by
Mia Anderson
Senior Interior Design Writer

Mia writes practical guides about AI interior design, room visualization and layout planning, focused on workflows that help people make confident decisions about real rooms.

Redesign Your Room with DecorAI

Upload a photo, pick a style, and get a photorealistic makeover in seconds. Free to start.

Download DecorAI on the App StoreGet DecorAI on Google Play

Related articles